Publicidad
Idiomas disponibles
Idiomas disponibles
English
Introduction
Dear customer, thank you for choosing a RAIKKO
read the manual and the safety and warning instructions carefully to
ensure trouble-free operation of your purchased product.
Product includes
• 1 RAIKKO
PUMP Vacuum Speaker
®
• 1 Micro-USB charging and extension cable
• 1 carrying bag
Overview
1. On/Off
2. Volume control
6. Lock
10
PUMP Vacuum Speaker
product. Please
®
5. BuddyPlug
4. Status LED
3. Charging/audio socket
7. Connection cable
English
Opening the resonance chamber
To open the PUMP Vacuum Speaker and produce the full volume,
slide the lock (6) on the back of the PUMP Vacuum Speaker to the
left. As you do so, hold the two halves of the speaker together to
prevent them for springing apart suddenly and to relieve pressure
on the locking mechanism.
To close, push the PUMP Vacuum Speaker together until the lock
engages. Connect the headphone socket (3.5 mm) of the PUMP
Vacuum Speaker to an audio source using the connection cable (7)
that is up in the base. If the integrated cable is not long enough, you
can also connect the loudspeaker via the audio plug of the Micro-
USB cable supplied.
Caution: Do not pull the open PUMP Vacuum Speaker apart:
the integrated spring expands the soundbox to the
appropriate volume.
Switching on
Press and hold the on/off switch (1) for 2–3 seconds. The status
LED (4) will turn blue when the PUMP Vacuum Speaker is switched
on. Press and hold the switch again to turn the PUMP Vacuum
Speaker off.
Volume
When you switch the PUMP Vacuum Speaker on, the volume is set
to a medium level. Increase the volume by sliding the spring switch
(2) to the right (VOL+) or decrease the volume by sliding it to the
left (VOL-).
PUMP Vacuum Speaker
11
Publicidad
