Agri-Fab 45-0320 Manual Del Usuario página 6

5. (Figure 4) Attach the brush assembly with the black (Figure 4) (Figure 4) Attach the brush assembly with the black
brush retainer to the left end of the brush shaft using
two 1/4" x 1" hex bolts (G) and 1/4" nylock nuts (I). The
brush retainer marked with black ink must be placed to
the middle of the sweeper.
6. (Figure 4) Turn a wheel to rotate the brushes. (The (Figure 4) (Figure 4) Turn a wheel to rotate the brushes. (The
wheels drive the brushes in one direction only.) The
overlap bristles should be on the back side of the brush
as it rotates.
BRUSH RETAINER
MARKED BLACK
7. (Figure 5) Assemble the angle bracket (DD) to the (Figure 5) (Figure 5) Assemble the angle bracket (DD) to the
sweeper housing using a 5/16" x 3/4" hex bolt (F) and
a 5/16" nylock nut (J). Make sure the bracket is turned
as shown and aligned straight with the housing and
then tighten.
5/16"
NYLOCK NUT (J)
ANGLE
BRACKET (DD)
5/16" x 3/4"
HEX BOLT (F)
1/4" x 1"
HEX BOLT (G)
1/4" NYLOCK NUT (I)
ENGLISH
8. Cut off the plastic tie that holds the height adjustment
tube in place.
9. (Figure 6) Assemble the R.H. hitch tube to the sweeper (Figure 6) (Figure 6) Assemble the R.H. hitch tube to the sweeper
housing using two 5/16" x 1-1/2" carriage bolts (D), and
two 5/16" nylock nuts (J). Do not tighten yet. Repeat
for the L.H. hitch tube.
4
5/16" x 1-1/2"
CARRIAGE BOLT (D)
10. (Figure 7) Fasten the hitch tubes together using two (Figure 7) (Figure 7) Fasten the hitch tubes together using two
5/16" x 2-1/2" hex bolts (A), 5/16" small fl at washers
(L), and 5/16" nylock nuts (J). Do not tighten yet.
5
5/16" x 2-1/2"
HEX BOLT (A)
6
6
5/16" NYLOCK NUT (J)
7
5/16"
NYLOCK NUT (J)
5/16" SMALL FLAT
WASHER (L)