Weed Eater VS2000BV Manual De Instrucciones página 6

b_ower tubes. The rotating blades can cause
serious injury
1. Insert the tip of a screwddver into the latch
area of the vacuum inlet.
Vacuum Inlet Cover
2. Gently tilt the handle of the screwddver to-
ward the front of the unit to release the
latch while pulling up on the vacuum inlet
cover with your other hand.
3. Hold the vacuum inlet cover open until up-
per vacuum tube is installed.
Vacuum
Inlet
Cover
Vacuum Inlet
4. Align thetabs on the inside of the vacuum in-
let with the slots on the upper vacuum tube.
6. Align slanted end of lower vacuum tube as
shown. Firmly push lower vacuum tube
into upper vacuum tube.
Slanted end of
HOW TO CONVERT UNIT FROM
VACUUM USE TO BLOWER USE
1. Remove the elbow tube and vacuum bag
by turning the knob counterc{ockwise to
loosen the elbow tube.
2. Remove the vacuum tubes by turning the
tubes clockwise.
3. Close the vacuum inlet cover and make
sure it is tatched c{osed.
4. Reinstall the blower tubes (see SLOWER
TUBE ASSEMBLY)
SHOULDER STRAP ADJUSTMENT
1. Hold the unit as shown with the muffler side
facing away from your body and clothes.
2. Pass the shoulder strap over your head
and onto your right shoulder.
3. Extend your left arm toward the rear of the
vacuum bag.
4. Adjust shoulder strap until the vacuum
bag/shoulder strap seam lies between
your thumb and index finger.
5. Make sure air flows freeiy from the eibow
tube into bag. tf bag is kinked, the unit will
not operate properly.
Tab
Slot
5. Push the upper vacuum tube into the vac-
uum inlet. Turn the tube counterclockwise
until a ctick is fa{t to secure the tube to the
blower unit.
-6-