IKRA RTA 2118 LI Instrucciones De Manejo página 16

5) Appropriate handling and use of battery-operated
power tools
a) Make sure that the device has been switched off
before inserting the battery. Inserting a battery into
a switched-on power tool may lead to accidents!
b) Only use charging devices recommended by the
manufacturer to charge the batteries. Charging
units are usually designed for certain types of batter-
ies; if used with other types there is a risk of fire!
c) Only use batteries designed for your power tool.
The use of other batteries may lead to injury and risk
of fire!
d) Keep unused batteries clear of paper clips, coins,
keys, nails, screws or other small metal objects
that may bridge the contacts. A short circuit be-
tween the battery contacts may lead to burns or fire!
e) Improper use may result in fluid leaking out of
the battery. Avoid any contact with battery fluid.
Flush with water in case of contact. If battery fluid
should get into your eyes seek medical advice ad-
ditionally. Leaking battery fluid may lead to irritations
of the skin or burns!
4. Instructions for using the battery
1. When the hedge shears are delivered, the replace-
able battery is not charge. Before starting the ma-
chine for the first time, the battery must be charged.
2. You must never open the battery.
3. Never throw the used batteries in fire - RISK OF
EXPLOSION!
4. Connect the battery charger only to mains with such
a voltage as stated on the type-bearing plate.
5. Use only the original battery.
6. Never charge the battery with a battery charger from
other producer. This can result in the battery being
damaged or it can result in an injury due to over-
heating.
7. During a long-term operation, the battery may heat
up. Let it cool down before charging it.
8. Do not store the battery charger and the batteries
within children's reach.
9. Do not use the battery charger in an environment
with vapors or inflammable fluids.
10. Charge the batteries only at a temperature within the
range of 10°C to 40°C.
11. Store the battery at temperatures up to 30°C only.
Higher storage temperatures may result in damage
to the battery. The ideal storage temperature range
is 10-15°C.
12. Never short-circuit the contacts of the batteries and
never interconnect them with metal objects.
13. When transporting the battery, take care that the
contacts are not interconnected, do not use metal
transportation containers.
14. Short-circuit of the battery can lead to explosion. In
any case, the short-circuit connection will damage
the battery.
15. Check the cable regularly on whether it is damaged.
If the cable is damaged, have it replaced.
GB | Operating Instructions
16. The battery is equipped with a deep-discharge pro-
17. Before storing the batteries for the wintertime, charge
5. Disposal of accumulators
Please observe the following directions for the disposal
of your accumulator/battery. Batteries are not to be put
into the rubbish. As a consumer you are legally obliged to
return used batteries and accumulators. At the end of the
duration of your apparatus, the batteries or accumulators
have to be taken from the apparatus, disposing of them
separately. You have the possibility of delivering your old
batteries and accumulators to the local collecting points
of your municipality or to your dealer or to the distribu-
tion centers.
6. Charging the batteries
• To take out the battery, press both push-buttons on
• Connect the battery charger to the socket. Make sure
• Connect the charging set to the charging station using
• The start of the charging process is indicated by
• The period of charging amounts approximately to 5
• t is not required to monitor the charging time.
• Pull the plug of the charging unit if it is not in use.
• If the battery is not lit up, check if there is electric cur-
Note: The battery is equipped with a deep-discharge pro-
tection feature: the tool is automatically switched off if the
battery is discharged. Recharge the battery immediately
if this should be the case.
7. Assembly of the protection cover
Put the protection cover on the trimmer's housing with
the location tab of the protection cover resting under the
support at the motor housing (Fig. 1). Then, firmly push
the protection cover on the trimmer's housing until the
fixture locks in place.
Attention:
GB-3
tection feature: the tool is automatically switched off
if the battery is discharged. Recharge the battery
immediately if this should be the case.
them fully once more.
the sides designated with the number 1 and take out
the battery (fig. 1)
that the voltage stated on the battery charger corre-
sponds with the mains voltage in your socket.
the jack plug of the charging set with the socket on the
top of the charging station.
the red control light. After the charging process has
been completed, the electronic control automatically
switches off the charging process. The red control
light extinguishes thereby indicating the end of the
charging process.
hours. During the process of charging, the battery
heats up. This is normal and it indicates no defect.
rent in the socket. If the charging of the batteries is not
possible, give the battery charger and the batteries to
a service shop.
After assembly, the protection cover will
(fig. 3)
(Fig. 1)