Operation - Omnitronic TM-1000 Manual Del Usuario

5 OPERATION

5.1 Start-up
Please refer to the explanations under Operating Determinations.
Press both battery tray buttons and open the battery cover on the rear panel.
If replacing the batteries, remove the old batteries from the battery compartment.
Caution!
Danger of explosion when battery is replaced improperly.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty battery in accordance with the instructions of the manufacturer.
Insert the 2 mignon-batteries (type AA) and make sure that the poles are correct.
Close the battery cover.
With the ON/OFF-switch, you can switch the device on and off. The battery symbol in the LCD-display
indicates if the power supply is sufficient.
When the batteries are getting weaker, the battery symbol is getting smaller. In this case, the batteries have
to be replaced.
If the display does not show anything when switching on, there are either no batteries inserted or the poles
are wrong.
In order to have a long battery life, you should only use alcaline batteries.
Select the desired frequency via the mini switches: press and hold the Set-button for 3 seconds, the display
shows "Freque". Press the Up or Down-button in order to select the desired frequency. Press the Set-button
in order to store the settings.
If the signal-input at the receiver is too high, you can attenuate the signal output level via the Gain-selection:
use the adjusting pole in order to turn the control until the desired gain is adjusted.
Press and hold the Up-button for 3 seconds in order to lock the pocket transmitter (LocOn). In this mode, the
user cannot carry out undesired changes. In order to unlock the pocket transmitter, once more press and
hold the Up-button for 3 seconds (LocOn)
Plug the microphone lead into the microphone input socket.
Screw the antenna into the antenna socket.
Attach the pocket transmitter via the belt clip to the belt or waistband.
If the microphone is not used, switch the transmitter off via the operation selector. If the presentation etc. is
over choose OFF. If the device will not be used for a longer period of time, remove the battery in order to
avoid battery leakage.
11/22 00025565.DOC, Version 1.5