Puky SD 1 Manual De Instrucciones página 7

Maintenance and care
Check all parts every half year for possible
wear (more often in the case of more intense
use) and also the correctness of the screw
connections. Self-tightening nuts are hard to
loosen and must be replaced after complete
disassembly!
In order to maintain the high, design-specified
safety levels, all worn or defective parts are to
be immediately replaced by original PUKY
spare parts. For safety reasons, the vehicle
should not be used until it has been repaired.
Bent or deformed parts should not be repaired
but instead should be replaced.
Parts subject to wear: Wheels, crank bearing.
The tricycle must not be cleaned using a high-
pressure cleaner. Clean the tricycle using a
mild soapy solution and carefully wipe dry
using a soft cloth. Avoid the tricycle coming
into contact with corrosion-promoting materials
(road salt, sea water, fertiliser). The tricycle
must not be stored in a damp room.
Unpacking and scope of delivery
Do not use sharp objects to open the packag-
ing or for removing any protective materials.
You could inadvertently scratch the paintwork
or damage parts of the tricycle.
z Remove all parts from the packaging.
z Remove the protective materials.
z Check the delivery for completeness and
integrity. Should parts be missing, please
contact your specialist dealer before begin-
ning any further work.
User Manual
The delivery comprises of (Figure A):
1. Frame
2. Fork incl. front wheel and pedal crank
3. Seat
4. Rear axle
5. Screw to fasten the seat (plastic bag)
Assembly
The assembly instructions are contained on
the last pages of these instructions.
The following tools are required for
assembly (Figure B):
1. Spanner 10 mm
2. Allen key 5 mm
Small parts which are required during assem-
bly (e.g. screws and washers) must be kept
out of the reach of small children. There is a
danger of suffocation as a result of swallowing
the parts. Also keep all packaging materials
away from children.
In order to prevent accidents or injuries occur-
ring later, the assembly must be carried out
very carefully by an adult. Take sufficient time
to do this. Several assembly steps require
manual skill and practise in handling tools (e.g.
spanner). If you are unsure, then please con-
tact your specialist dealer or a workshop.
7
GB