Puky SD 1 Manual De Instrucciones página 8

Play tricycle Speeldriewieler
At several points it is necessary to tighten
screws with a certain force. This force is given
in Newton meters (e.g. 2 Nm). If a screw is not
tightened with sufficient force, then the con-
nection will possibly still be too loose and un-
safe. If the force is too great, then screws and
other parts may be damaged and destroyed.
Figure 1: Insert rear axle into the frame.
Align the square nut to the rear.
Figure 2: Insert screws and tighten.
Figure 3: Remove the rubber band and take
off one of the two washers.
Figure 4: Slide the steering tube with bearing
shells all the way onto the fork shaft.
Place the washer back on and align
the lug of the fork shaft to the rear.
Figure 5: Slide the handlebar all the way onto
the fork shaft. Tighten the screw.
Align the slot in the handlebar to the
rear. Firmly press down the cap until
it snaps into position.
Figure 6: Slide the seat onto the frame from
the rear and screw tight.
Operation
Figure 7: Adjusting the seat position
Figure 8: State ready for use.
8