Publicidad
Idiomas disponibles
Idiomas disponibles
3.2
Installation conditions
3.3
Defining the mounting
position
4.
Installation
4.1
Definition
4.2
General safety
instructions for the
installation
4.3
Installation description
Distance between two antennas (internal or external)
•
at least 25 cm
Bending radius when installing the cables
•
max. 5 cm
NOTE
The product can be damaged by condensed water on cold components!
> Before installation, please ensure that all product components are at the ambient
temperature!
> Store products at the installation site for an appropriate period prior to installation.
The installation is illustrated based on an exemplary situation in these installation instructions (larder unit
with 3 keyed alike doors or locks).
•
Adjust the individual mounting position to customer-specific conditions.
•
In the event of any doubts regarding the mounting position, please contact the manufacturer.
keyed alike operation
All connected locks (EFL 3) open simultaneously when presenting an authorised user key.
individually addressable operation
Only certain locks (EFL 3) open when presenting an authorised user key, although several locks are
connected.
The following basic instructions must be applied during the installation:
Basic safety instructions
> Do not carry the product by the cable.
> Check all delivered product components for damages prior to the installation! Never install
damaged product components, but complain to the manufacturer.
> Never modify or replace plug and cable.
> Do not omit any delivered parts. Adhere to the assembly sequence.
> Do not install any parts that are not approved by the manufacturer.
Electrical safety
> Do not install and store product components and cables near hot surfaces, heat sources, easily
flammable materials or areas with direct sunlight.
> Never expose product components and cables to humidity and never install or store near water,
damp, aggressive or potentially explosive areas.
> An earthed shockproof socket installed according to national regulations must be available for
the electrical connection of the PS1 or PS2 power supply unit. The connection data of the
socket must match the connection data of the power supply unit (see Chapter "Technical Data"
of the separate operating instructions).
> Install product components so that the power cable of the power supply unit can be connected
directly to the socket. The use of output extenders or adapters is prohibited!
> Position product components so that they are permanently accessible for maintenance.
> Do not jam, crush, bend or damage the cable during the installation (e.g. by drilling, cutting).
Do not place cable over sharp edges or corners. Install cable at a sufficient distance to movable
or rotating parts.
> Clearly (but without any strain) tie together excessively long cables by using cable ties or a
strain relief device. The cable routing must be clearly recognisable.
> Do not place cables on the floor. They could become a hazardous tripping risk and become da-
maged by being walked on.
WARNING
Life-threatening electric shock during the installation with a plugged in mains plug!
The entire installation must occur without power!
> Never connect the mains plug to the socket during the installation.
> Even after completing the installation, do not connect the mains plug. The "initial start-
up" is thereby immediately started.
> Prior to connecting the mains plug for the first time, read the chapter "Initial Start-Up" of
the separate operating instructions.
7
Publicidad
