Installation Instructions - hafele R2 Dialock Instrucciones De Montaje Y De Servicio

Mounting and Operating Instructions

Installation instructions

Safety note
Before beginning installation, ensure that the power supply is
switched off. The installation work should be done by a qualified
electrician only, as complex wiring is required. Unsuitable tools may
cause damage to the wall terminal.
Please note that the wall terminal is intended only for switching
electrical equipment with max. 1 A continous current and 2 A peak
current (1 s max.).
Incorrect or incomplete installation may cause irreparable damage to
the system.
Installation requirement
For installation, first determine suitable positions and
locations for the reader and control units. This must
take due account of the equipment being operated
(e.g. door lock, barrier etc.). In addition, the recessed
socket (fig. 4) for the reader unit and the cable must be
installed as shown in the circuit diagram (Fig. 5).
Installation
Fig. 4
The following operations are required:
• Installation of reader unit
• Installation of control unit
• Electrical installation
Installation of required cablework
Before installing, always remember to switch the power off.
For the installation of the electrical connections, observe the following con-
nection diagrams.
Wall terminal R2 Dialock - status: 12.2016 - 732.29.132
21