artograph 225-359 Manual Del Usuario página 3

Tray Assembly
3.
Take the Y-bracket and mount into
upper tube assembly. Aline holes and secure
using the #8 x 1/2 scews with a #2 Phillips
screwdrivier (not included) (Fig. 3).
Figure 3
Upper Y-Bracket
4.
Slide a spacer onto the round pegs
(Fig. 4) located on each side of the tray.
While holding the spacers in place, set
the tray into the slots on top of the upper
Y-bracket (Fig. 4A) so that the spacers
are sandwiched between the tray and the
upper Y-bracket.
Figure 4
Spacer
•
Spacer
•
Tray
•
•
Figure 4A
•
Spacer
Upper Y-Bracket
5.
With tray resting in slots of the upper
Y-bracket, attach the locking knobs with
screws and tighten (Fig. 5). Your Mobile
Projector Floor Stand is now ready for use.
Your projector can simply be placed in the
tray facing either direction.
Screw
Figure 5
•
Locking Knob
Caution: When using the projector on
the stand in a dark room, take careful note
where the electrical cord is. You may want to
loosely secure the cord to the bottom of the
tube assembly to keep it out of your way.
•
Spacer
•
•
Tray
•
Locking Knob
•
Tray
•
3