Ec Declaration Of Conformity (Original); Fcc Statement / Ic Statement - Hilti PMP 45 Manual De Instrucciones

This constitutes Hilti's entire obligation with regard to
warranty and supersedes all prior or contemporaneous

12 EC declaration of conformity (original)

Designation:
en
Type:
Year of design:
We declare, on our sole responsibility, that this product
complies with the following directives and standards:
2004/108/EC, 2006/95/EC, 2011/65/EU, EN ISO 12100.
Hilti Corporation, Feldkircherstrasse 100,
FL‑9494 Schaan
Paolo Luccini
Head of BA Quality and Process Man-
agement
Business Area Electric Tools & Ac-
cessories
01/2012

FCC statement / IC statement

-CAUTION-
This equipment has been tested and found to comply
with the limits for a class B digital device, pursuant to
part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment gener-
ates, uses, and can radiate radiofrequency energy and,
if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio com-
munications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment
on and off, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Re-orient or re-locate the receiving antenna.
• Increase the distance between the equipment and
receiver.
• Connect the equipment to an outlet on a circuit differ-
ent from that to which the receiver is connected.
• Consult the dealer or an experienced TV/radio techni-
cian for assistance.
18
comments and oral or written agreements concerning
warranties.
Technical documentation filed at:
Point laser
Hilti Entwicklungsgesellschaft mbH
PMP 45
Zulassung Elektrowerkzeuge
2009
Hiltistrasse 6
86916 Kaufering
Deutschland
Matthias Gillner
Executive Vice President
Business Area Electric
Tools & Accessories
01/2012
-NOTE-
Changes or modifications not expressly approved by
the party responsible for compliance could void the user's
authority to operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received,
including interference that may cause undesired oper-
ation.
This device complies with the requirements defined in
RSS-210 of IC.
Operation is subject to the following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received,
including interference that may cause undesired oper-
ation.