Peg-Perego Navetta Elite Instrucciones De Uso página 15

• This product is only suitable for children who are unable to
sit up by themselves.
• This product is designed for children from birth up to a
weight of 9 kg. When used in vehicles it is designed for
weights of up to 10 kg.
• During use in vehicles, always fasten the safety harness.
When using the product as a carriage, remove the harness
and place it in the special pocket.
• Only use the product on surfaces that are hard, horizontal
and dry.
• Do not leave other children playing unattended near the carriage.
• Take care when adjusting the mechanisms (handle,
backrest) with the child present.
• Regularly check the handle (or the handles) and the
bottom of the carriage to make sure that there are no signs
of breakage or damage.
• When using the carriage with a stand, check the maximum
length of the carriage specified on the stand.
• When using the pram with a Peg Perego stand, check the
maximum pram length allowed on the stand.
• The pram is intended for transportation purposes and
should not replace the cot at home.
• In the bassinet, the baby's head must never be lower than
its body.
• Do not use this product after 7 years from the date of
production indicated on the structure. The natural ageing
of the materials may mean that it is no longer compliant
with standards.
• Do not add any mattress are not approved by the
manufacturer.
The images referring to the textile details may differ
from the collection purchased.
Instructions for use
Using the Navetta Elite
1 HOOD: to lift the hood completely, pull it until it clicks.
2 To lower the hood, press the handle and push the hood
down simultaneously.
3 The hood comes with a mesh insert so that the baby can
be seen from any position. Pull the zippers as shown in the
picture and pull the hood further, to reveal the mesh insert.
4 FOOT MUFF: to secure it correctly:
Unfasten the hood button.
Position the foot muff in the bassinet.
5 Button the foot muff following the sequence as illustrated.
The foot muff in the figure is properly attached.
6 Fasten the velcro straps as illustrated.
7 The velcro straps can be used to fasten the foot muff to
the hood, so as to protect the child even more against the
elements. Unfasten the sides of the foot muff (arrow_a),
unfold it upwards (arrow_b) and fasten it to the hood with
the velcro straps (arrow_c);
8 CARRY HANDLE: this is built into the hood.
To carry the bassinet, lift the hood, if lowered, and hold the
handle placed above it.
• Before lifting the bassinet, make sure the hood is in the
correct position for transport.
• Before unfastening and lifting the bassinet from the frame,
adjust the backrest to its lowest position (figure 11).
9 ROCKING POSITION: The base of the Navetta Elite has a
special shape which allows you to rock the child when it is
placed on a flat surface.
10 COT POSITION: It is possible to make the Navetta Elite into a
non-rocking cot by opening out the two legs under the base.
11 ADJUSTING THE BACKREST and THE FOOTREST: with the
COMFORT SYSTEM, backrest and footrest can be adjusted
simultaneously. Pull the knob outwards (fig_a) while turning
it (fig_b) to raise or lower the backrest and the footrest.
12 FOUR SEASONS SYSTEM: as shown in the figure, it is
possible to adjust the product's air circulation from the
base in order to prevent condensation.
To create a cool, well ventilated environment (in summer),
open the holes by moving the 4 levers outwards. To limit
the entry of air (in winter), move the levers inwards.
Ganciomatic system
13 Ganciomatic is the quick, practical system that allows you
to attach the Navetta Elite to the Ganciomatic clips of a
stroller or the base of a chassis.
To attach the Navetta Elite, put it on the stroller or the
chassis and press with both hands until it clicks into place.
15