Tabla de contenido
Publicidad
E n g l i s h
(Special Features, Continued)
Delay Start
This feature allows you to delay the start of
the selected wash cycle for up tp 19 hours.
Front Control
1. Press the On/Off Button
2. Press the Delay Start button. Continue
pressing the Delay Start button until the LED
display shows the number of hours of delay
you desire.
3. Press the button for the desired wash
cycle. You can change the cycle at any time
during the delay.
Top Control
1. Open the dishwasher door far enough to
expose the control buttons.
2. Press the On/Off Button
3. Press the Delay Start button. Continue
pressing the Delay Start button until the LED
displays shows the number of hours of
delay you desire.
4. Press the button for the desired wash
cycle. You can change the cycle at any time
during the delay.
Top Rack Only
Cycle
™
This cycle allows you to save energy,
water, and detergent by washing loads
small enough to fill only the upper rack. Note:
The Top Rack Only cycle does not reduce
wash time.
To use the Top Rack Only Cycle:
1. Load the upper rack. Figure 27 shows a
typical mixed load placed correctly in the
upper rack.
2. Press the On/Off button.
3. Press the button for the desired wash
cycle.
4. Press the Top Rack Only button.
OptiMISER™
This feature, used in conjuncton with the
Figure 27/Ilus. 27
other wash cycles, reduces wash time by
about 30%. NOTE: OptiMISER™ is NOT used
with the Quick Wash or Rinse and Hold
cycles.
To use OptiMISER™:
1. Press the On/Off button.
2. Press the desired cycle selection button.
3. Press the OptiMISER™ button.
Cycle Completion Signal
This feature is a tone that sounds when
your Siemens dishwasher finishes washing
and drying your dishes, and is available
ONLY on Top Control models. You can either
disable the tone, or you can set it at one of
two volumes (dishwashers with this feature
leave our factory with the tone set on the
lowest volume).
(Continued on Next Page)
34
Special Features | Caractéristiques Spéciales | Caractísticas Especiales
Publicidad
Tabla de contenido
