Maintenance And Cleaning - Bosch GKS 24 V Instrucciones De Servicio

– When setting the cutting depth, take into con-
sideration that the cutting depth is reduced by
the height of the guide rail.
– Align the circular saw with the guide
adapter 28 in such a way that the teeth of the
saw blade lie against the edge of the rubber
lip.
– Make sure that the guide rail is not sawn into
(Fig. II and III).
II
28
0°-Cut
– Tighten the winged screw for the parallel
guide 10 to ensure a firm connection between
the guide adapter 28 and the circular saw.
– Remove the circular saw from the guide
rail 29.
– Place the guide rail on the workpiece in such a
way that the rubber lip lies exactly along the
cutting edge (marked line) and tighten using
screw clamps 27.
The guide rail 29 must not protrude over
the workpiece on the side of the cut.
(see figure F
– Position the saw, ensuring that the guide-rail
adapter 28 is seated firmly.
– Saw through the material, applying moderate
and steady feed.
Note: Two guide rails can be connected to one
with use of the connection piece 30 (acces-
sory). Clamping is carried out with the four
screws located in the connection piece.
18 • 1 609 929 C62 • TMS • 11.02.02
1 - 45°-Cut
)

Maintenance and Cleaning

Before any work on the machine itself, re-
move the battery.
For safe and proper working, always keep
the machine and the ventilation slots clean.
The retracting blade guard must always be able
to move freely and freely and retract automati-
cally. Therefore, always keep the area around the
retracting blade guard clean. Remove dust and
III
chips by blowing out with compressed air or with
a brush.
If the machine should fail despite the care taken
28
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
Saw blades that are not coated can be protected
against corrosion with a thin coat of acid-free oil.
Before use, the oil must be removed again, oth-
erwise the wood will become soiled.
Resin and glue residue on the saw blade produce
poor cuts. Therefore, clean the saw blade imme-
diately after use.
In all correspondence and spare parts orders,
please always include the 10-digit order number
given on the nameplate of the machine.
English - 6