Publicidad
Idiomas disponibles
Idiomas disponibles
3. Remove panels andsetpanels aside o na covered surface.
4. Check t hatgrounding clipisattached tothelower p anel.
5.
Lower
panel
clip
Slide nut and ferrule
onto tubing.
Copper
tubing
only: Slide nut, then ferrule,
about
1" (2.5 cm)
onto copper
tubing.
NOTE:
To avoid
vibration
during
operation,
route the water
supply
line so that it does not touch the dishwasher
base, frame
or motor.
6.
Add 90 ° elbow
fitting
to the water
supply
line.
Connect
the 3/8" compression
fitting
to the water
supply
line
prior to installing
the unit into the cabinet
opening.
Attach
such
that the 3/4" connection
is facing
upward.
Copper
tubing
only: Put the tubing
into the 90 ° elbow
fitting
as
far as it will go (the copper
tubing
bends and kinks easily).
Slide the nut and ferrule forward
and start the nut onto the
elbow
threads.
Flexible
braided
connection:
Secure nut to
elbow
using 5/8" open ended
wrench
or adjustable
wrench.
NOTE:
Do not use Teflon ®t tape with compression
fittings.
Remove terminal
box cover.
- If you are direct
wiring:
Install a UL Listed/CSA
Approved
clamp
connector
to the terminal
box. If using conduit,
use a
UL Listed/CSA
Approved
strain relief.
- If you are installing
a power
supply cord
kit, do so now,
following
kit instructions.
The power supply
cord
kit must be
UL Listed and marked
for use with dishwashers
(that is, Power
Supply
Cord Kit Part Number
4317824).
8°
. Terminal
I....................................................................................
q_
box cover
Z>Cable d amp
connector
Dishwasher
wires
Measure
height
of cabinet
opening
from
underside
of countertop
to
floor
where
dishwasher
will be
installed
(you need
the lowest
point).
Check
chart
for that
height
opening.
Put wheels
in the required
position.
%
C_
C_
1
Wheel_
3
Minimum
cutout
height
333/4'' (85.7 cm)
337/8' ' (86
cm)
34" (86.4 cm)
341¼'' (87
cm)
341/2'` (87.6 cm)
Wheel
position
remove
remove
1
2
3
iNumber
of
turns on
front
leg
all the
way up
all the
way up
10
Perforation
on Blanket
remove
keep
keep
keep
keep
9°
Turn both front leveler
legs to the same
height.
If the minimum
cutout height
is less than 34"
(86.4 cm), the rear wheels can be removed
for additional
clearance.
This will allow
the
dishwasher
to fit into a 337/8'' (86 cm) high
cutout,
but the dishwasher
will be more
difficult
to move into position.
If the wheels
Front leg
are removed,
cover the floor
when moving
the dishwasher.
If the minimum
cabinet
opening
height
is 333/4" (85.7 cm), a
section
in the insulation
blanket
can be removed
by cutting
along
the perforation.
t®Teflon
is a registered
trademark
of E.I. Du Pont de Nemours
and
Company.
10
Publicidad
