Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
Electrical Shock Hazard
Disconnect electrical power at the fuse box or circuit
breaker box before installing dishwasher.
Failure to do so can result in death or electrical shock.
1.
Disconnect
power.
2.
Turn off water
supply.
Follow
the steps in this section if you are installing
the
dishwasher
in an existing
cabinet
opening
with utility
hookups.
•
If you are installing
the dishwasher
in a cabinet
opening
that
does not have hookups,
follow
the steps under "Prepare
cabinet
opening
where there are no existing
utility
hookups"
section.
1.
Check
that
the water
Water
D rect
linereachestothefront.
_.!wJre
left
of opening
where
the
water
connection
will
be made.
2.
Check
that
the direct
6" (!5.2 cm.)...
_
wire
reaches
to the
front
right
of opening
where
the
electrical
connection
will
be
made.
If the water
line and the direct
wire reach far enough
into the
opening,
proceed
to the next section "Install
the drain
hose." If they
do not reach far enough,
follow
the steps under "Prepare
cabinet
opening
where there are no existing
utility
hookups."
Install the drain hose
IMPORTANT:
Always
use a new drain
hose when installing
a new
replacement
dishwasher.
1.
Drill a 11/2 '' (3.8 cm) diameter
hole in cabinet
wall or floor
on
the side of the opening
closest to the sink.
2.
Connect
drain
hose to waste tee or waste disposer
using one of
the following
methods:
•
Option
1, Waste
disposer
- with air gap
•
Option
2, No waste disposer
- with air gap
•
Option
3, Waste
disposer
- no air gap _
•
Option
4, No waste disposer
- no air gap _
_An air gap is recommended.
Helpful
Tip: To reduce
the vibration
of the hose, keep the hose
away
from the floor
and the edge of the hole where it passes
through
the cabinet.
Option
1, Waste
disposer
- with air gap:
1.
Remove the disposer
knockout
plug. Cut end of drain
hose if
needed
(do not cut ribbed
section).
2.
Attach
drain
hose to air gap with large
spring-type
clamp.
If
the drain
hose was cut, use a 11/2 '' to 2" (3.8 to 5 cm) screw-type
clamp _.
3.
Use a rubber
hose connector _ with spring-
or screw-type
clamps _ to connect
air gap to disposer
inlet.
This connection
must be before
the drain
trap and at least 20"
(50.8 cm) above
the floor
where
dishwasher
will be installed.
gap
Large
clamp
hose
Drain
trap
4.
Insert drain hose through
hole
cut in cabinet
to the front
center
of opening
where
drain
connection
will be
made.
_Parts available
from local
plumbing
supply
stores.
6
Publicidad
