Delta 36-714B Manual De Instrucciones página 14

HOW TO ADJUST THE TABLE INSERT
Disconnect the machine from the power source!
Make sure that the table insert (A) is always
level with the table.
Place a straight edge (B) Fig. 29 across the table at both
ends of the table insert (A).
To adjust, loosen the screw (D) Fig. 29 and turn the adjusting
screws (C) Fig. 29 with the supplied hex wrench.
HOW TO INSTALL THE TOOL HOLDERS
Disconnect the machine from the power source!
Install the fence holders (A) Fig. 30 using four (4) 1/4"-20 x
3/8" self-tapping screws.
Install the wrench hook (B) using two (2) M4 x 8mm self-
tapping screws.
HOW TO INSTALL THE DUST PORT
Disconnect the machine from the power source!
Attach the dust port (D) Fig. 31 using four 1/4-20 x 3/8"
self-tapping screws.
HOW TO ASSEMBLE AND OPERATE THE MITER GAUGE
Disconnect the machine from the power source!
Refer to the instruction sheet that came with your 36-946 miter gauge for assembly and operation instructions.
B
D
C
14
A
C
Fig. 29
Fig. 30
B
A
D
Fig. 31