Ariens A173K22 Manual Del Propietário página 17

TROUBLESHOOTING - See appropriate section in manual unless directed
PROBLEM
Poor cut -
uneven
to a qualified service center,
CAUSE
1. Worn, bent or loose blade.
Excessive
vibration
Starter rope
hard to pull
Grass catcher
not filling
(If so equipped)
Hard to push
Loss of drive
or slowing of
drive speed
2. Wheel heights uneven.
3. Buildup of grass, leaves
and trash under mower.
1. Worn, bent or loose blade.
2. Bent engine crankshaft.
1. Engine flywheel brake is on
when control bar is released.
2. Bent engine crankshaft.
3, Blade adapter broken.
4. Blade dragging in grass.
1. Cutting height too low.
2. Lifton blade worn off.
3. Catcher not venting air.
1. Grass is too high or wheel
height istoo low.
2. Rear of lawn mower
housing or cutting blade
dragging in grass.
3. Grass catcher too full.
4. Handle height position not
right for you.
1. Belt wear.
2. Belt off of pulley.
3. Drive cable worn or broken.
4. "Loose" drive control system.
CORRECTION
1. Replace blade. Tighten
blade bolt.
2. Set all wheels at same
height.
3, Clean underside of
mower housing.
1. Replace blade. Tighten
blade bolt.
2. Contact a qualified service
center.
1. Depress control barto
upper handle before
pulling starter rope.
2. Contact a qualified service
center.
3. Replace blade adapter.
4. Move lawn mower to cut
grass or to hard surface.
i 1. Raise cuttingheight.
i2. Replace blade.
3. Clean grass catcher.
i 1. Raise cutting height.
2. Raise rear of lawn mower
housing one (1) setting
higher.
3. Empty grass catcher.
4. Adjust handle height to suit.
1. Check/replace drive belt.
2, Check/reinstall drive belt.
3. Replace drive cable,
4. Adjust drive control.
t7