GE 26 Manual Del Propietario Y Instalación página 18

Installation Instructions
INSTALLING THE REFRIGERATOR
(cont.)
[] REMOVETHE REFRIGERATOR DOORS(cont.)
[] Lift the door straight up to remove.
[] Remove the two bolts using a 3/16" Allen wrench
and two Phillips-head screws from the center hinge.
Set the hinge, bolts and screw aside.
[] REPLACINGTHE REFRIGERATOR DOORS
[] Installthe center hinge on each side.
[] Lower the refrigerator door onto the center hinge pin.
Ensurethat the plastic hinge pin thimble is on the center
hinge pin or inside door hinge pin hole located in the
bottom of the door.
[] Securel U tape the door shut with masking tape
or have a second person support the door.
18
[] REPLACING THE REFRIGERATOR DOORS
(cont.)
[] Insert the top hinge pin into the hinge hole on top
of the refrigerator door. Hake sure the door is aligned
with the cabinet and opposite door.Attach the hinge to
the top of the cabinet. Do not tighten bolts completelU.
[] On left-hand doors, pass the wires and water line
through the top hinge pin.Then connect the water line
and two connectors.
[] Attach the ground wire with a Phillips-headscrewdriver
at the right and left hinge.
[] Hake sure the gasket on the door is flush against the
cabinet and is not folded. Hake sure the door is straight
and the gap between the doors is even acrossthe front.
While holding the aligned door in place, tighten the top
hinge bolts.
[] Reconnectthe two connectors at each side of the top
cap and reattach the three Phillips-headscrews on top.
[] Reinstall the rectangular caps removed in Step 5.