Biesemeyer T-Square 78-055B Manual De Instrucciones página 10

ATTACHING GUIDE TUBE TO FRONT RAIL
1. Insert 1/4-20 x 5/8" (16 mm) hex head screw (II) down
through a hole in front rail and thread on a 1/4-20
serrated flange nut (JJ) a few turns, as shown in Fig. 15.
2. repeat for all other holes in front rail, making sure to
fill the holes at both ends of the rail.
3. Remove right side guide tube end cap (I1) Fig. 16A.
Use a T25 screwdriver.
4. Slide guide tube hole (KK) Fig. 16B onto first hex head
screw at the left side (as shown in Fig. 17). Make sure
ruler tape (LL) Fig. 16B or Fig. 17 is to the front of the
saw before you start. Work your way down and slide
guide tube around all hex head screws (II) Fig. 15 until
metal edge (MM) Fig. 18 on right end of guide tube
(NOT THE PLASTIC CAP) is flush with right end (NN)
of extension table. Use the included template (Z) to be
sure straight edge of guide is flush with wood part of
table, as shown in Fig. 18
5. Fully tighten all flange nuts (JJ) Fig. 15, attaching
guide tube to the rail.
6. Replace right side guide tube end cap (I1) Fig. 16A.
FIG. 16A
LL
FENCE CLAMPING HANDLE ASSEMBLY
1. Place fence clamp handle end cap (OO) Fig. 19 on
post (PP). Then place fence clamp handle body (QQ)
on end cap (OO) and place other end cap (SS) on
body (QQ).
2. Place fence clamp handle screw (TT) into end cap
(SS) all the way down and tighten into post (PP).
3. Finished handle should look like (RR).
I1
FIG. 17
II
JJ
LL
MM
QQ
OO
10
FIG. 15
KK
FIG. 16B
NN
Z
FIG. 18
PP
SS
TT
FIG. 19
RR