Biesemeyer T-Square 78-055B Manual De Instrucciones página 8

ATTACHING EXTENSION TABLE
TO THE RIGHT UNISAW WING
1. Place 5/16" flat washers (Q) Fig. 8 on 5/16-18 hex
head screws (R) and thread a few turns into the holes
(S) in the right extension wing.
2. Holding the extension table, line up four slots (T)
Fig. 9 in the extension table with these four screws (R)
Fig. 8.
NOTE: make sure the flat washers are against the heads
of screws (R) Fig. 9 (inset).
3. Using the leveling feet (U and V) Fig. 10, make sure
the extension table is level and in the same plane with
the Unisaw right extension wing and tighten the four
screws (R) Fig. 8 from underneath the extension table.
FRONT RAIL TO SAW
1. Assemble front rail (W) Fig. 11 to the front edge of
the saw table using the two 5/16-18 x 1" (25 mm) flat
head hex socket cap screws and 5/16-18 serrated
flange nuts.
2. screws are inser ted throught the two larger
countersunk holes (one shown at (X) Fig. 11) in the
front rail and into the two holes (Y) in the front of the
saw table.
3. Then, fasten those screws underneath the saw table
using the serrated flange nuts. Tighten finger tight.
REAR RAIL TO SAW
1. Align the two non-countersunk holes (one shown at
(AA) Fig. 12) in the rear rail with the two holes in the
rear edge of the saw table.
2. Place 3/8" lock washers on the two 3/8-24 x 1-1/4"
(31.2 mm) long hex head screws. (Hardware shown at
(BB) Fig. 12).
3. Place screws through the two holes in the rail and
thread them into the two threaded holes — one shown
at (CC) Fig. 12 — in the saw table, BUT DO NOT
FULLy TIGHTeN THese yeT.
W
FIG. 11
Y
X
V
8
S
Q
FIG. 8
extension
table
saw wing
flat washer
R
T
FIG. 9
U
FIG. 10
BB
CC
AA
FIG. 12
R