Publicidad
Idiomas disponibles
Idiomas disponibles
USING
THE BLOWER
To blow away debris on the
ground
Fitting
the blower
tube
and
nozzle
on the blower
[_k
WARNING:
When fitting the blow-
er tube and nozzle, the engine must
be switched
off.
The blower
tube (T) has a begged slot
mounting
system to the unit. To install or
remove the blower tube (or collection
bag
tube for BV2126), the tube clamp bolt must
be removed•
Align slot in the b_ower air out-
let with the raised rib on the tube and insert
tube until the holes in the tube and housing
align. Be-insert
the tube clamp bolt and
tighten.
!.½ ,,
°i
The nozzles
(U) have a bayonet
mount for
connection
to the blower
tube• Air is chan-
neled through
the blower tube to the
nozzles,
where the air discharge
velocity
increases
and the air stream
discharge
pat-
tern is formed
to provide best performance.
The length of the blower tube can be ad-
justed by twisting the nozzle to the left to
disengage
the bayonet
mount and sliding
the nozzle to the appropriate
position.
Twist the nozzle to the right until a click is
fe{t to re-secure
the nozzle
Blowing
Before you begin blowing,
put on tile re-
quired safety equipment•
WARNING:
When working
with
the blower,
wear the required
per-
sonal
safety
equipment:
1. Hearing
protection.
2. Eye protection.
g. Protective gloves.
4. Face mask in dusty environments.
BV2126 can be used with a shoulder
strap
for extra comfort• The strap should be
worn over the shoulder
as shown•
A
WARNING:
Never point the blower
nozzle at people
or animals.
The
high-velocity
air stream
can contain
particles
that may cause serious
injury, especially
if the blower
has
previously
been used for vacuuming.
Be careful,
particularly
if left hand
operation
is applied. Avoid any di-
rect body
contact
with
inlet cover
area. Keep jewelry,
loose
clothing,
or clothing
with
loosely
hanging
straps,
ties, tassels,
etc., away from
inlet cover
area.
545154659 Rev. 3 7/1/08
English-13
Publicidad
