Publicidad
Idiomas disponibles
Idiomas disponibles
DESCRIPTION
Ground wire
• The ground wire (G) reduces static
beNd-up during operation in dry condi-
tions.
/
Inlet cover
• An inlet cover (H) is located on the side
of the fan housing•
Opening
this cover
allows access
for cleaning
and inspect-
ing the impeller (BV2126 only).
If the vac-
uum tube is used, it must be fitted to the
opening
in the inlet cover• To open the
inlet cover, use a tool to lift the edge of
the cover
opposite
the hinge (indicated
by arrow
on inlet cover).
H
j•
WARNING:
Never start the blower
if the inlet cover
is not closed,
is
damaged
or cannot
be closed
(except if the vacuum
tube is fitted).
Cutter8
(BV2126)
• Two cutters (J) are fastened to the impeF
let. The cutters are there to mulch leaves
and other debris that have been vacuumed
before they enter the collection bag.
Blower
tube
and
nozzle
NOTE:
The tube clamp bolt and nut must
be installed
prior to initial use (see the gen-
eral description
of the blower
on page 6)
• The blower tube (K) has a begged slot
mounting system to the unit
To install or
remove the bbwer tube (or coHecflon bag
tube for the BV2126), the tube clamp bolt
must be removed•
Align slot in the blower
air outlet with the raised rib on the tube
and insert tube until the holes in the tube
and housing alk:jn. Re-insert
the tube
clamp bolt and tighten.
• The nozzles
(L) have a bayonet
mount
for connection
to the blower tube• Air is
channeled
through
the blower
tube to the
nozzles,
where the air discharge
velocity
increases
and the air stream discharge
pattern
is formed to provide
best perfor-
mance.
The length of the blower tube
can be adjusted
by twisting the nozzle to
the left to disengage
the bayonet mount
and sliding the nozzle to the appropriate
position.
Twist the nozzle to the right until
a click is felt to resecure
the nozzle
K
Starter
device
and
8tarter
handle
• The starter device
(M) is located on the
side of the engine shrouding
and en-
gages the crankshaft
only when the
starter handle (N) is pulled.
_%,.,
j_"2
M J
/ _
Fuel
cap
• The fuel cap (O) is located at the rear of
the engine shrouding
on the fuel tank
and has a seal to prevent fuel from leak-
ing out.
Air filter
• The air filter (P) consists
of a fiber filter
medium
in a resilient
frame. The air filter
should
be cleaned
at specific
intervals
(see Maintenance
section).
Otherwise,
the blower
will consume
too much fuel,
the performance
will be reduced
and an
oily deposit
may form on the spark plug
electrodes•
54515465g Rev. 3 7/1/08
English-g
Publicidad
