5751009900
17-04-2003
AIR CONDITIONER
With the unit turned off, the function selector
11
is in the "O" position. To turn the unit on in
air conditioning mode, proceed as follows:
1. Rotate the function selector knob clock-
wise:
• Place the large crystal symbol
with the reference mark to operate the
unit in air conditioning mode at maximum
fan speed.
• Place the small crystal symbol
with the reference mark to operate the
unit in air conditioning mode at minimum
fan speed.
2. Now set the required temperature by
rotating the room thermostat knob.
Note
The temperature is not expressed in degrees.
We therefore recommend rotating the room
thermostat knob
position.
When
reached the required level, rotate the ther-
mostat knob slowly clockwise until the ther-
mostat is activated, turning the unit off. This
programs the unit to the precise level of com-
fort required which will then be automatically
maintained by the thermostat with consider-
able energy savings. When regulating the
thermostat, the air conditioning function is
temporarily interrupted and the unit contin-
ues to operate in fan only mode.
HOW TO DEHUMIDIFY
When the appliance is working as an air condi-
tioner, it automatically reduces the excess
humidity in the air present in the room. This is
eliminated through the exhaust tube
If only the elimination of the excess humidity
in the room is desired without lowering the
temperature, simply turn the function selector
knob in a clockwise direction until the
symbol is reached. The excess condensed
humidity automatically gathers in the tank
8
. It is also possible to carry out continuous
drainage of the condensed humidity, follow-
ing the instructions aside.
10
15:07
Pagina 10
S e l e c t i n g f u n c t i o n s
in line
in line
15
to the maximum cool
room
temperature
has
19
.
DEHUMIDIFICATION ONLY
Position the appliance in the room without
inserting the tube; in this way the dehumidi-
fied air will exhaust directly into the room.
Note
In the dehumidifying mode, air colder than the
room temperature will exhaust from the air
exhaust grill. Conversely, air warmer than room
temperature will be exhausted from the cou-
4
pling
on the back side of the appliance.
TO TURN THE UNIT OFF COMPLETELY, SET THE
11
FUNCTION SELECTOR
TION AND UNPLUG FROM THE SOCKET.
REMOVING COLLECTED WATER
Condensation will be collected in the
removable tank
.
8
It's also possibe to drain it continuosly.
CONTINUOUS EXTERNAL DRAINING
THIS UNIT EMPLOYS AN EXCLUSIVE CONDEN-
SATION RECYCLING SYSTEM TO DISPOSE OF
EXCESS MOISTURE. IN NORMAL CONDITIONS,
CONDENSATION IS DISPOSED OF AUTOMATI-
CALLY. WHEN THE HUMIDITY IS PARTICULARLY
HIGH, AN EXCESS OF CONDENSATION MAY
BUILT UP IN THE TANK
PENS, THE INDICATOR LIGHT
ON INDICATING THAT THE TANK SHOULD BE
EMPTIED. WHENEVER CONDITIONS OF HIGH
HUMIDITY MAKE THE PROBLEM RECURRENT,
YOU MAY DISCHARGE THE EXCESS WATER
DIRECTLY INTO A DRAIN, USING THE RUBBER
TUBE SUPPLIED. THE TUBE SHOULD BE INSERTED
INTO THE HOLE PROVIDED, AFTER HAVING
REMOVED THE RUBBER STOPPER. (see figure
below).
MAKE SURE THE TANK IS PUT BACK CORRECTLY
OTHERWISE THE LIGHT
14
TO THE "O" POSI-
8
. WHEN THIS HAP-
COMES
14
WILL REMAIN ON.