Speedlink Powerstixx 2.1 Manual De Instrucciones página 10

1. Connect the two satellite speakers to the output sockets ("L"+ "R") on
D
the back of the subwoofer.
GB
2. When doing this, connect the speaker with red cinch plug to the "R"
socket and the speaker with the white cinch plug to the "L" socket.
F
3. Use one of the two supplied cables to connect your sound source
(e.g. sound card, CD player, etc.) to one of the two input sockets on
E
the back of the subwoofer.
Note: You can use the second cable to simultaneously connect a second
I
sound source to the system. You can switch between the sound sources
with the Input button on the remote control.
4. Connect the subwoofer to the power supply.
5. Move the switch on the back of the subwoofer to ON.
LED: The LED on the front of the subwoofer flashes blue several times
and then goes out. The system is then ready.
6. Press the On/Standby button on the remote control to switch on the
system.
LED: The LED on the front of the subwoofer lights blue, indicating that
the speaker is switched on.
2. Functions of the remote control
Button:
On/Standby:
Input
Function:
Switches the system
to standby or active
mode. The system
is not completely
disconnected from the
power supply in this
mode!
Changes between
2 connected sound
sources (to "Input 1"
and "2").
10
LED
The LED lights blue
or red in active mode
depending on the
chosen sound source.
If the system is put
in standby mode
(LED goes out) and
re-activated, the last
chosen sound source
is always active.
Blue LED: the sound
source connected
to Input 1 is active
(default setting).
Red LED: the sound
source connected to
Input 2 is active.