WAGNER HT4500 Manual De Instrucciones página 6

EN
 If heat gun is damaged upon receipt, DO NOT USE. Return to point of
purchase.
4.4 HEAT GUN USE AND CARE
 DO NOT use the heat gun if the switch does not turn it on and off. Any
power tool that cannot be controlled with the switch is dangerous AND
SHOULD NOT BE USED.
 Maintain power tools. Check for misalignment or sticking of moving
parts, breakage of parts and other conditions that may affect operation
of the power tool. If damaged, DO NOT USE.
 Use the heat gun and accessories in accordance with these instructions
and in the manner intended for the particular type of power tool, taking
into account the working conditions and the work to be performed.
4.5 SERVICE
Have your heat gun serviced only by Wagner or its appointed agents to
ensure the safety of such is maintained to avoid a safety hazard.
5. ADDITIONAL SAFETY INSTRUCTIONS FOR HEAT GUNS
 DO NOT place your hand over the air vents or block the vents in any way.
 The nozzle and accessories of this tool become extremely hot during
use. Let these parts cool down for 30 minutes before touching.
 Always switch the tool off before putting it down.
 DO NOT leave the tool unattended while it is switched on.
 A fire may arise if the appliance is not used with care.
 Heat may be conducted to combustible or readily-flammable materials
that are out of sight. DO NOT use in a damp atmosphere where flammable
gases may be present or near combustible materials such as paper,
cardboard or fabric (ignite easily when exposed to high temperatures).
 Allow the tool to cool fully before storing.
 Ensure adequate ventilation as toxic fumes may be produced.
 DO NOT use as a hairdryer.
 DO NOT obstruct either the air intake or nozzle outlet as this may cause
excessive heat build-up resulting in damage to the tool.
 DO NOT direct the hot air blast at other people or animals.
6