GE 16 Manual Del Propietario E Instalación página 6

About the fresh foodcompartmentshelves.
Shelf supports at various levels allow you to custom-space your shelves. Not all features are on all models.
Half-Width Shelves
r_]qlt up
One end of the shelf rests on a molded
side-wall support; a bracket on the other
end hooks into a track (m the rear
cabinet wall.
To remove, lift the shelf up at fl'ont,
then
off the SUl)l)ort and out of the track.
To replace, select desired shelf height.
With shelf ti'ont raised slightly, hook the
bracket's top lug into the track, then
lower the shelf onto the SUl)l)ort.
NOTE:Theshelf to the @t of the trackb
designedto hookinto the @t-hand slot,
the shelf to the left is designedto hook
into theleft-handslot.
Full-Width Shelves
Some models have a steel wire sliding
sheik a stationary tempered glass shelf or
two steel wire stationary shelves. These
shelves can be moved to another place
in the fl'esh food compartment.
The flfll-width sliding shelf has stop-locks.
When placed correctly on the shelf
sui)ports, the shelf will stop beflwe coming
complemly ()tit ()f the refrigerator and will
not tilt when you place fi)od on it or
remove food from it.
To remove the full-width shelves, lift the
rear of the shelf and pull forward.
Toremove a full-width shelf when the fresh
food compartment door cannot be opened
fully, lift the rear of the sheik pull
forward and down, tilt the shelf and
take it ()tit.
II
Spillproof Shelves
(on some models)
Spillproof shelves have special edges
to hel I) i)revent spills ti'om dripping
to lower shelves. To i'elllOVe or replace
the shelves, see the above instructions.