Refrigerator Use; Ensuring Proper Air Circulation; Using The Controls; Adjusting Control(S) - Whirlpool 5GR2SHKXLQ01 Manual De Uso Y Cuidado

Ensuring Proper Air Circulation

In order to ensure proper temperatures, you need to permit
airflow between the refrigerator and freezer sections. As shown in
the illustration, cool air enters through the bottom of the freezer
section and moves up. Most of the air then flows through the
freezer section vents and recirculates under the freezer floor. The
rest of the air enters the refrigerator section through the top vent.
Do not block any of these vents with food packages. If the vents
are blocked, airflow will be prevented and temperature and
moisture problems may occur.
IMPORTANT: Because air circulates between both sections, any
odors formed in one section will transfer to the other. You must
thoroughly clean both sections to eliminate odors. To prevent
odor transfer and drying out of food, wrap or cover foods tightly.

Using the Controls

For your convenience, your refrigerator controls are preset at the
factory. When you first install your refrigerator, make sure that the
controls are still preset to the mid-settings as shown.
NOTE: To turn your refrigerator off, turn the refrigerator control to
the word OFF or until the word OFF appears. Your product will
not cool when the refrigerator control is set to OFF.
Mid-setting "3"
Mid-setting "3"

REFRIGERATOR USE

IMPORTANT:
Give your refrigerator time to cool down completely before
adding food. It is best to wait 24 hours before you put food
into the refrigerator.
If you add food before the refrigerator has cooled completely,
your food may spoil. Adjusting the Refrigerator and Freezer
Controls to a higher (colder) than recommended setting will
not cool the compartments any faster.
The mid-setting(s) indicated in the previous section should be
correct for normal household usage. The controls are set
correctly when milk or juice is as cold as you like and when ice
cream is firm.
If the temperature is too warm or too cold in the refrigerator or
freezer, first check the air vents to be sure they are not blocked.
If you need to adjust temperatures, use the settings listed in the
chart below as a guide. On models with two controls, adjust the
refrigerator temperature first. Wait at least 24 hours between
adjustments and then recheck the temperatures.
CONDITION/REASON:
REFRIGERATOR too cold
- Not set correctly for your
conditions
REFRIGERATOR too warm
- High use or room very warm
FREEZER too cold
- Not set correctly for your
conditions
FREEZER too warm/too little ice
- High use or heavy ice usage
Turning the Ice Maker On/Off
NOTE: Do not force the wire shutoff arm up or down.
To turn the ice maker on, simply lower the wire shutoff arm.
NOTE: Your ice maker has an automatic shutoff. As ice is
made, the ice cubes will fill the ice storage bin and the ice
cubes will raise the wire shutoff arm to the OFF (arm up)
position.
Mid-setting "4"
REFRIGERATOR
4

Adjusting Control(s)

Ice Maker

(on some models - Accessory)
FREEZER
4
ADJUSTMENT:
REFRIGERATOR or
TEMPERATURE Control
one setting lower
REFRIGERATOR or
TEMPERATURE Control
one setting higher
FREEZER or
TEMPERATURE Control
one setting lower
FREEZER or
TEMPERATURE Control
one setting higher
11