Tamper Protection; Troubleshooting; Reset To Factory Default - Evespring HSE03 Guia De Instalacion

Tamper Protection

Tamper switch is set inside the housing of HSE03 to prevent it from being
forcibly removed from the wall. Removing the unit from backplate will release
the tamper switch and generate a full alarm condition.
Install Power Adapter (Optional)
The power adapter is an optional accessory. An optional 600mA @ 6V DC
power adapter can be purchased if needed. A cable track is set inside the unit
for you to secure the power adapter. Please install the power adapter as
follows:
1.
Connect the plug of power
adapter to the DC jack
inside the unit.
Maintenance
* Do not immerse this unit in water or any other liquid.
* Four 1.5V Alkaline LR14 batteries are supplied in the HSE03. When battery
is low, a red LED will flash every 30 seconds. When this situation occurs,
replace the batteries as soon as possible.
2.
Route the cable along the
cable track.

Troubleshooting

The troubleshooting table lists some possible causes and solutions. Please
contact your original retailer or nearest service center if the below solutions
cannot solve your problem.
Symptom Possible Cause
HSE03 LED indicator No battery is inserted or
stops displaying battery is flat
HSE03 failure
The display function of 1.The binding process
HSE03 LED indicator has failed
is operating properly,
but the siren doesn't 2.The siren cannot
respond to alerts and communicate with the
system changes. Homesys gateway.

Reset to factory default:

To reset HSE03 back to factory default state:
1. Insert the batteries into the unit
2. Press and hold the learning key "F" (as shown in Figure 5) for more than 3
seconds until the green strobe LED turns off, then release the learning key.
The Green LED will flash repeatedly. This implies HSE03 has now entered
binding mode and is waiting to receive binding signals from the gateway.
3. Press and hold the learning key for more than 6 seconds and release
within 30 seconds, during which it will sound every 0.5 seconds with green
LED turned on. The learning procedure is completed when a longer beep
tone has sounded and the LED will flash orange every 2 seconds.
Specifications
Power adaptor (option) 600 mA@6V DC
Battery Type 1.5V LR14 x 4
Battery Life About one year in standby mode at 25°C
Operating Frequency 868MHz (EU)/ 923MHz (America)
** Specifications are subject to change and improvement without notice.
www.everspring.com
3F., No. 50, Sec 1, Zhonghua Rd., Tucheng Dist.,
New Taipei City 23666, R.O.C
4
Recommendation
Check if 4 batteries are inserted
properly
Send the unit to the service
center and do not open it
1.Please follow the instructions
for Manual binding.
2.Place the siren closer to the
gateway.
A501112386R01