SEVERIN KS9827 Instrucciones De Uso página 12

Familiarisation
1. Cold storage compartment
2. General and bottle storage
3. Adjustable foot
4. Removable storage rack
5. Drip tray
6. Temperature control (on the rear)
The upper section of the unit contains a cold-
storage compartment that can be closed by a door.
Before using for the first time
– Remove any exterior and interior packaging materials completely, including the adhesive strips.
– Before it is connected to the mains, the unit must be thoroughly checked for transport damage,
including its power cord.
– Clean the unit as described in the section De-frosting and cleaning.
– To ensure proper functioning, wait for about 2 hours before connecting the unit and switching it
on after it has been positioned.
– When the unit is first switched on, a slight 'new' smell may be noticed. However, this will
disappear once the cooling process has begun.
Installation
 The appliance should be set up in a well-ventilated, dry room.
 It should be operated in an ambient temperature of 16 to 32 °C and a relative humidity of max.
70 %.
 Do not use the appliance outdoors.
 Ensure that the plug is accessible and can be removed from the wall socket at any time.
 Do not expose the appliance to direct sunlight, and do not position it next to any heat sources
(radiators, cookers etc). If this cannot be avoided, however, a suitable insulation must be in
installed between the heat source and the unit.
 The unit must not be installed inside a cabinet, nor directly below a hanging cupboard, shelf or
similar object .
 Do not place any objects on top of the unit, and do not otherwise cover it.
 If the floor is uneven, the adjustable foot can be used to compensate and ensure optimum
stability.
Ventilation
Ensure that there is enough space around the unit so that the air circulation round and behind it is
not obstructed. (Rear and sides 5 cm, top 10 cm.)
Reversible door
If required, the door may be reversed, i.e. from right-hinged (default installation) to left-hinged.
Warning: Always disconnect the unit from the mains before any maintenance or repair work is
carried out.
12