AEG DH 1690 Manual De Uso página 6

6 www.aeg.com
a maximum of 30 cm, while leaving
the extraction speed of the motor
unchanged.
C. Speed 2 switch
D. Speed 3 switch
E. Speed 4 switch
F. 10-minute timer
This is used to switch off the extraction
system automatically as well as to close
the extraction panel 10 minutes after it
has been enabled.
Use the high suction speed in cases
of concentrated kitchen vapours. It is
recommended that the cooker hood suction
is switched on for 5 minutes prior to cooking
and to leave in operation during cooking
and for another 15 minutes approximately
after terminating cooking.
Hood Calibration
After the hood has been installed, the
aspiration panel must be calibrated.
This operation is necessary to regulate the
power exstraction of the aspiration panel.
Pushing the ON/1 "B" the aspiration panel
rises. After it has reached a height of 18 cm
from the cooktop, press OFF "A", to stop the
extraction then the Timer "F" and after sec.
the OFF button "A".
The hood will carry out the calibration of
its aspiration panel rising and retracting for
some centimeters.
During this phase, the buttons on the
pushbutton control panel blink.
Anti-pinch safety:
if an obstacle obstructs the closure of the
Downdraft, the closure is stopped and the
trolley goes up.