GB
ENGLISH
from loosening, due to engine vibration.
19- Never remove the fuel tank plug when the engine is running.
20- Clean off any spilled fuel.
Move the machine away from the refuelling point (at least 3
m) before starting the engine.
21- Never use fuel to clean the machine.
22- Do not check for spark close to the spark plug hole.
1. - STOP SWITCH
2. - THROTTLE CONTROL LEVER
3. - SAFETY LEVER
4. - HANDGRIP
5. - PRIMER (CARBURETTOR DISCHARGE)
6. - FUEL TANK PLUG
7. - FUEL TANK
8. - ENGINE ON/OFF HANDLE
9. - AIR FILTER
10.- AIR LEVER (STARTER)
11. - REDUCTION GEAR
23- Allow the engine to cool and drain the machine of fuel
before storage.
24- Store the machine away from heat sources, raised from
the floor.
25- Make sure that the transmission shaft has been installed
and tightened properly.
3. DESCRIPTION
12. - OPERATOR GUARD
13. - FRONT SLIDING HANDGRIP
14. - TRANSMISSION SHAFT FASTENING CLAMP
15. - CLAMP SCREWS
16. - TRANSMISSION SHAFT
17. - HOOK
18. - RUBBER HOOK PROTECTION
19. - SPRING HOOK
20. - ANTI-VIBRATION SYSTEM
21. - HARNESS
22. - HARNESS SUPPORT
14