Delta LA200 Manual De Instrucciones página 11

C
ADJUSTING THE TOOL REST
Disconnect the machine from the power source!
For most applications, position the tool rest as close as possible to the workpiece and approximately 1/8" above the workpiece
centerline.
1. To position the tool rest base (A) Fig. 21 along the lathe bed, loosen the locking lever (B), slide the tool rest base to the
desired position, and tighten the lever (B).
2. To adjust the height of the tool rest (C) Fig. 21, loosen the lever (D), raise or lower tool rest, and tighten the lever (D).
3. You can adjust the clamping device on the tool rest base by adjusting the nut (E) clockwise to tighten or counter-clockwise
to loosen the clamping action.
C
Fig. 21
Fig. 23
ADJUSTING THE TAILSTOCK
1. To slide the tailstock along the lathe bed, loosen the locking
lever (A) Fig. 23. Slide the tailstock (B) into position, and
tighten the lever (A). The clamping device for the tailstock
was set prior to shipping. However, if the clamping action
needs adjustment, remove the tailstock and tighten (or
loosen) the nut (C) Fig. 24 on the bottom of the tailstock.
Re-attach the tailstock to the lathe bed.
2. To move the ram (D) Fig. 25, in or out, loosen the locking
lever (E) and turn the handwheel (F). Tighten the lever (E)
after adjusting the ram (D).
NOTE: Total ram (D) travel ranges from 0" to 1-1/2".
Fig. 19
A
D
B
A
B
D
C
G
Fig. 22
Fig. 24
E
D
11
Fig. 20
E
C
F
Fig. 25