Getting Started; Install The Batteries; Insert A Memory Card - Coby Snapp CAM3001 Manual De Instrucciones

getting started

Â
Please read and complete the following steps to begin using your digital video camera.

Install the Batteries

1. Remove the battery compartment door by slid-
ing it toward the base of the camera.
2. Insert two (2) "AA" alkaline batteries. Be sure to
match their polarities to those indicated in the
diagram inside the battery compartment.
3. Replace the battery compartment door and
snap it into place.
The battery used in this device may present
a fire or chemical burn if mistreated. Do not
disassemble, incinerate, or heat the batteries.
Used batteries should be disposed of safely.
Keep batteries out of the reach of children.

Insert a Memory Card

This camera records to SD or SDHC memory cards.
The maximum supported card size is 8GB.
Getting Started Getting Started
1. Make sure that the write
protection switch on the
memory card is set to the
"unlocked" position.
2. Install the memory card by
inserting it gently into the
card slot on the left side of
the video camera. Push the
card until it clicks into place. Make sure the card
is properly aligned as indicated by the marking
next to the card slot.
3. To release and remove the card, press the card
in; it will spring out of the slot. Grasp the card by
its edge to remove it.
To avoid data corruption, turn off the digital
video camera before inserting or removing
a memory card.
Page 7 Page 7