Tabla de contenido
Publicidad
Adjustments
Miter Scale (Vernier) Indicator
Adjustment
1.
Raise the head assembly to the full-up position.
Through the slot 1 in the kerf insert, loosen the Phillips
2.
screw 2 that holds the indicator 3 in place (Figure 12).
3.
Position the indicator 3 to align with the 0° miter mark 4.
Tighten the screw 2.
Crown Molding Detent
Adjustment (Bevel)
1.
Move sliding fence to proper position. (See Sliding Fence
on page 54.)
2.
Push detent stop pin 5 completely in as shown in
(Figure13).
Keep pin in out position for all operations
!
CAUTION
except when cutting crown molding.
3.
Loosen bevel lock handle 6. Rotate head assembly until
the stop pin 5 rests on top of the crown molding
adjustment bolt 8 and the pointer is indicating 33.9° on
the bevel scale. Tighten the bevel lock handle 6
(Figure 13).
4.
Measure the angle between the blade and the table. If it
is not 33.9° follow the procedures for the crown molding
detent adjustment.
Crown Molding Detent Adjustment
Loosen jam nut 7 with the wrench provided.
a.
Loosen bevel lock handle 6.
b.
Turn crown molding adjustment bolt 8 with the
c.
wrench provided until blade aligns a the square at
33.9°.
d.
Tighten bevel lock handle 6.
Tighten jam nut 7.
e
FIG. 13
6
42
FIG. 12
1
2
4
3
8
5
7
Publicidad
Capítulos
Tabla de contenido
