before washing.
– Push the speed control switch
into position «0» and unplug
the device to turn it off.
– Pull the plug to remove it from
the electrical outlet, not the
power cord.
– Make sure that the power
cord does not hang down from
the table or work surface and
also prevent it from coming
into contact with hot surfaces,
including the stove.
– Unplug the hand mixer
whenever it is not in use, if
you want to mount or remove
accessories or clean the
device.
– Under no circumstances
start up an electrical device
if its power cord or plug
are damaged, after it has
malfunctioned or if the device
has been damaged in any
other way. In such cases,
always bring the device to the
nearest authorized service
center for inspection, repair or
adjustments.
– Never attempt to replace the
power cord of your device
since special tools are required
to do this properly. Have
such repairs and power cord
replacement work performed
exclusively by a manufacturer
authorized service center in
order to warrant that your
device remains safe to use.
– Never immerse power cords,
2
motor housings and plugs into
water or other liquids, as this
could cause fires, electrical
shock or injuries.
–
To prevent the risk of
the safety shut-off reactivating
the device, the device must
not be connected to power via
an external switching device,
such as a timer or connected
with a power circuit that is
regularly turned on or off by
the power company.
– The device must not be
connected to mains while it is
being cleaned.
– Do not touch any rotating parts.
– Keep clothing, jewelry, fingers,
hair and utensils away from
rotating parts to prevent
severe injuries to persons and
damages to the unit.
– When blending liquids and
in particular hot liquids, use
a high container or reduce
the amount of liquid you are
mixing to prevent the risk of
splashing.
– Make sure that the speed
setting is in the 0-setting and
that the device is unplugged
before you clean it or turn it
off.
– Never allow the device to run
unsupervised.