Technical Data; Before Starting The Equipment - Toolson PRO-MG 330 Manual De Instrucciones

4. Technical data

Operating voltage of the drive unit: ..230V ~ 50 Hz
Power input: .............................................. 135 W
Idle speed n : ..........................10000-35000 min
0
Clamping range: ................................. 0,5-3,2 mm
Attachments Ø max.: ................................ 55 mm
Attachment length max.: .......................... 22 mm
Spindle length max.: ................................. 40 mm
Protection class: ...........................................II /
Weight: .....................................................0.61 kg
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level ..................... 68,5 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level ....................... 79,5 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 60745.
Vibration emission value a
K uncertainty = 1.5 m/s
The specifi ed vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equip-
ment is used and may exceed the specifi ed value
in exceptional circumstances.
The specifi ed vibration value can be used to
compare the equipment with other electric power
tools.
The specifi ed vibration value can be used for initi-
al assessment of a harmful eff ect.
Anl_PRO_MG_330_Teil1_SPK7.indb 17 Anl_PRO_MG_330_Teil1_SPK7.indb 17
-1
≤ 2.5 m/s
2
h
2
- 17 -
GB
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
5.1 Taking out the accessories (Fig. 4)
To be able to take out the accessories you must
pull the accessory mount (a) upwards.
5.2 Inserting the various tools (Fig. 5)
Danger! Before inserting a tool (and before
each tool change) switch of the drive unit and pull
the power plug.
1. Press the locking knob (4) and turn the collet
chuck until the bolt locks into place.
2. Remove the clamp nut (3), insert the mat-
ching clamping sleeve (11) and refi t the
clamp nut.
3. Insert the required tool into the sleeve and
tighten the collet chuck nut (3).
05.05.14 08:40 05.05.14 08:40