Description; Intended Use; Overview; Safety - GreenWorks CUF301 Manual Del Operario

EN
1

DESCRIPTION

1.1

INTENDED USE

The battery-powered cultivator is intended for loosening
of soil in an open garden area. This product is not
intended for commercial use. Do not use it for any task.
1.2

OVERVIEW

Figure 1-6
Upper handle
1
Lower handle
2
Wing nut
3
Bail switch
4
Safety lock button
5
Wheel assembly
6
Ring pin
7
2

SAFETY

Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3

INSTALLATION

• Replace the battery pack or the charger immediately
if the battery pack or charger cord is damaged.
• Exam that the machine is in the OFF status before
you install or remove the battery pack.
3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine
before use.
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
Tine A
8
Tine B
9
10 Tine C
11 Tine D
12 Hitch pin
13 Felt
WARNING
WARNING
WARNING
English
3.1.1 INSTALL THE HANDLE
Figure 2.
1. Align the holes on the upper handle with holes on
the lower.
2. Insert the bolts through the handles.
3. Use the wing nuts to tighten them.
3.1.2 INSTALL THE WHEEL
Figure 3.
1. Insert the wheel assembly into the support rod.
2. Align the wheel assembly hole to desired position.
3. Slide bolt through hole and attach hitch pin to bolt.
The wheel position of the machine is adjustable.You
can control the depth of operation through adjusting
the wheel position.
Wheels can be removed for greater tilling depth.
3.1.3 INSTALL THE TINES
Figure 6.
The cultivator has four tines —two inner tines stamped
B and C and two outer tines stamped A and D. For
correct operation of the unit, the tines must be installed
in the correct orientation.
1. Put the machine on a flat and smooth surface.
2. Place tine C on the tine shaft to the left of the gear
box. The stamped side of the tine should face away
from the gear box.
3. Place tine B on the tine shaft to the right of the gear
box. The stamped side of the tine should face away
from the gear box.
4. Place a felt washer on each side of the tine shaft,
and slide to rest against the inner tines.
5. Place the outer tine D on the left side of the tine
shaft. The stamped side should face in toward tine
C.
6. Place the outer tine A on the right side of the tine
shaft. The stamped side should face in toward tine
B.
7. To secure the tines to the tine shaft, insert the ring
pins into the holes located on either side of the tine
shaft.
The unit will not operate properly if the tines are
installed incorrectly. If you notice a problem with the
cultivating operation of the unit, check for proper tine
positioning.
4
NOTE
NOTE
NOTE