Operation - Hart HFSD01 Manual Del Operador

OPERATION

WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Battery products are always in operating condition.
Therefore, the switch should always be in the center
lock position when not in use or carrying at your side.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Driving screws with screwdriver bits
 Light-duty drilling
CHARGING
See Figure 1, page 9.
When charging the screwdriver, a red charge light on the
switch trigger side of the screwdriver will illuminate. This red
charge light will go off when the screwdriver is fully charged.
 Insert charger plug into input jack making sure it is
properly connected.
 Charger can be used with normal household current of
120 V, AC only, 60 Hz.
 Connect charger to power supply.
 After normal usage, a minimum of 9 hours of charging
time is required to fully recharge the screwdriver.
 Do not place charger in an area of extreme heat or cold.
It will work best at normal room temperature.
 Remove the product from the charger once it is fully
charged and ready for use.
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE/CENTER LOCK)
See Figure 2, page 9.
The direction of bit rotation is reversible and is controlled
by a selector located in the center of the handle. With the
screwdriver held in normal operating position, the direction
of rotation selector should be positioned fully upward for
forward motion. The direction is reversed when the selector
is fully down.
Setting the direction of rotation selector in the center
(locked) position helps reduce the possibility of accidental
starting when not in use.
NOTE: The screwdriver will not run unless the direction of
rotation selector is pushed fully up or down.
NOTICE:
To prevent gear damage, always allow the collet to
come to a complete stop before changing the direction
of rotation.
To stop the screwdriver, release the switch trigger and allow
the chuck to come to a complete stop.
LOADING/RELEASING BITS
See Figure 3, page 9.
Insert the bit into the collet and push the bit in as far as pos-
sible. To remove a bit, pull the bit straight out of the collet.
DRIVING SCREWS
See Figure 4, page 9.
 Check the direction of rotation selector for the correct
setting (forward or reverse).
 Hold the tool firmly and place the bit at the point where
the screw is to be driven.
WARNING:
Do not drive a screw where there is likely to be hidden
wiring behind the surface. Contact with a "live" wire
will make exposed metal parts of the tool "live" and
possibly shock the operator. If you must drive a screw
where hidden wire may be present, always hold tool by
insulated gripping surfaces (handle) when performing the
operation to prevent a shock to the operator.
 Depress the switch trigger to start the tool.
 Apply only enough pressure to keep driving the screw.
Do not force the tool. Let the tool do the work.
7 – English