TECshow HALO 740 XL Manual De Usuario página 7

Cooling Mode
To select Cooling Mode, press the ENTER button to
show the COOLING MODE on the display. Use the UP/
DOWN button to select Auto (Normal) or Low (Low
speed). Once selected, press the ENTER button to
setup. Press the MENU button back to the last menu
or let the unit idle one minute to exit menu mode.
Dimmer Curve
To select Dimmer Curve, press the ENTER button
to show the DIMMER CURVE on the display, use the
UP/DOWN button to select Linear, Square Law, In-
verse Squ. or S-curve. Once selected, press the EN-
TER button to store. Press the MENU button back to
the last menu or let the unit idle one minute to exit
menu mode.
Dimmer Modes
Optically Linear
Inverse Square Law
Linear The increase in light intensity appears to be
linear as DMX value is increased.
Square Law Light intensity control is finer at low
levels and coarser at high levels.
Inverse Square Law Light intensity control is coars-
er at low levels and finger at high levels. S-cure Light
intensity control is finger at low levels and high lev-
els and coarser at medium levels.
Dimmer Speed
To select Dimmer Speed, press the ENTER button
to show the DIMMER SPEED on the display. Use the
UP/DOWN button to select Fast or Smooth. Once se-
lected, press the ENTER button to setup. Press the
MENU button back to the last menu or let the unit
idle one minute to exit menu mode.
Display Setting
Enter MENU mode, select Display Setting, press the
ENTER button to confirm, use the UP/DOWN button
to select Display Inverse, Backlight Auto Off, Back-
light Intensity, Constrast Ratio ,Temperature unit,
Display Warning or Language.
Display Inverse
To select Display Inverse, press the ENTER button to
show the DISPLAY INVERSE on the display. Use the
UP/DOWN button to select No (normal) or Yes (dis-
play inverse). Once selected, press the ENTER but-
ton to store. Press the MENU button back to the last
menu or let the unit idle one minute to exit menu
mode.
Backlight Auto Off
Square Law
To select Backlight Auto Off, press the ENTER button
to show the BACKLIGHT AUTO OFF on the display.
Use the UP/DOWN button to select No (display al-
ways on) or Yes (display goes off one minute after ex-
iting menu mode). Once selected, press the ENTER
button to confirm and store. Press the MENU button
back to the last menu or let the unit idle one minute
to exit menu mode.
S-curve
Backlight Intensity
To select Backlight Intensity, press the ENTER button
to show the BACKLIGHT INTENSITY on the display.
Use the UP/DOWN button to adjust the intensity
from 1 (dark) to 10 (bright). Once selected, press the
ENTER button to setup and store. Press the MENU
button back to the last menu or let the unit idle one
minute to exit menu mode.
- Tecshow Halo 740 XL
English Version
P. 7