Cleaning And Storage - Clatronic BS 1248 Instrucciones De Servicio

CAUTION:
Never wash the filter in the washing machine, and please
do not use a hairdryer to dry it.
34
05-BS 1248 Neu.indd 34
Cleaning the Filter Element
CAUTION:
Always empty the dust contai-
ner first before removing the
filter element.
• Press the button to release
the dust container and then
remove it (see illustration 1).
• Turn the lid in the direction
„ " and then lift it off, inclu-
ding the filter element.
• Turn the filter element in the
„OPEN" direction to remove
it from the lid. Remove the
filter element (two parts)
and clean the main filter by
tapping out the contents and
gently brushing.
• Now replace the compon-
ents. Please then turn the
filter element in the CLOSE
direction until it is tight.
• Place the lid on the dust
container - the  arrow is
located above the „ " symbol
- and then turn it in the „ "
direction until it is tight.
Every third time the dust container
is emptied, or in the case of severe
soiling, clean the filter by allowing
water to flow through the filter
fabric against the direction in which
the vacuum cleaner blows. The
dust container should only be rein-
serted when it is completely dry!
Now place this back in position
once it has completely dried!
Motor protection filter
(inlet filter)
The inlet filter is located in the
dust container compartment. The
filter is located vertically in the
rear section of the dust housing.
Pull the filter out towards the front.
Clean the motor protection filter
approximately every 10th time
you empty the dust container. If
necessary, the filter can also be
washed in warm water without any
additives. Place it back into place
only once it is completely dry!
Outlet filter (13)
The appliance is also equipped
with an outlet filter. In order
to ensure that the filter works
correctly, we recommend that you
replace it every six months. It is
located on the rear part of your
appliance behind a ventilation
grid. Open the ventilation grille
by pressing the lever on its side.
Then pull the grille out towards
the front. Remove the filter and
clean as described above. Fit the
filter back into place and close
the ventilation grid by following
the steps above in the opposite
order.

IMPORTANT NOTE!
• Cleaning may become necessary after a shorter time,
depending on the conditions of use, e.g. when vacuuming
fine dust.
• If the suction power of your vacuum cleaner diminishes
please clean the filters as described.
• If the suction power suddenly diminishes during operation
this may be due to the filters being locked.

Cleaning and storage

WARNING:
• Before cleaning remove the mains lead from the socket.
• Under no circumstances should you immerse the device
in water for cleaning purposes. Otherwise this might result
in an electric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
Cleaning
• Clean the casing with a dry cloth.
• Clean the motor protection filter approximately every 10.
time the vacuum cleaner is emptied. Clean the filter in hot
water without additives. Put it back into place only once it is
completely dry.
Storage
• Let the iron cool down completely.
• Wind the cable completely.
• Insert the hook of the nozzle on the back of the device into
the parking aid (14).
• If you position the device horizontally: Please insert the hook
of the floor nozzle into the parking assistant on the rear of
the device.
• If you position the device vertically: Please insert the hook of
the suction tube into the parking assistant on the bottom of
the device.
25.03.2010 8:59:50 Uhr
M
P
P