Intended Use; Overview Of The Components - Clatronic DBS 3503 Instrucciones De Servicio

Intended Use

This appliance is intended for ironing of clothing and textiles.
It is intended for use in households.
Any other use shall be considered as not intended use and can
lead to material damage or even personal injury.

Overview of the Components

1 Steam jet button
2 Connecting tube
3 Mains lead
4 Base
5 Iron rest
6 Releasing device for handle "UNLOCK"
7 Water tank with lime filter
8 Handle
9 Lock for continuous steam
10 Steam jet button
11 Selector button SET
12 Control lamp
13 Temperature selection display
14 Lime filter cartridge
not shown
RELEASE button below the water tank. Releasing device of the
water tank
Instructions
Unpacking
• Remove any protective foils and stickers from the soleplate.
• Please unwind the lead completely.
Electrical connection
• Make sure that the iron voltage (see name plate) and the
line voltage match.
• The mains plug should only be inserted into a correctly
installed socket with earthing contact.
Power Requirements
The station has a total maximum wattage of 2400 W. With this
connected load a separate supply line protected by a 16 A
household circuit breaker is recommended.
CAUTION: Overload!
• If you use extension leads, these should have a cable
cross-section of at least 1.5 mm²
• Do not use any multiple sockets, as this device is too
powerful.
Turn on and off
Turn on:
Connect the mains plug to a properly installed
safety socket. The appliance is immediately
switched to operating mode. This is indicated
by the red control lamp in the display.
Turn off: Press the selector button SET (11) repeat-
edly until the red control lamp appears in the
display. Disconnect the mains plug from the
socket. The light in the display goes out.
Automatic shut-off function
The appliance has an automatic shut-off function.
• If the iron station is not in use it will shut off after 20 min-
utes. The red control lamp in the display flashes.
• Use the selector button SET (11) to reset the desired
temperature, if you want to continue ironing.
Function of the Handle (8)
The handle attached to the base serves for carrying the appli-
ance when the mains plug has been pulled from the outlet.
• To carry the appliance, raise the
handle until it engages (Fig. A).
A "click" confirms that the handle
has been locked. You can use the
handle for transport of the appli-
ance.
• To unlock the handle lock, press
both buttons "UNLOCK" (6) at the
same time and lower the handle
(Fig. B).
Electronic temperature adjustment using the selector but-
ton SET (11)
• Observe the ironing instructions on the clothes label.
• Select the temperature setting according to the following
table.
• Turn woolen clothes inside out to avoid shiny spots on the
fabric due to steam ironing. In addition, lay a thin cotton
cloth onto the fabric.
• The instructions in the table only refer to fabrics with no
additional surface treatment (gloss, impregnation, wrinkles,
etc.). Select a low temperature setting for fabrics with ad-
ditional surface treatment and iron them inside out.
• Press the selector button SET (11) to set the desired
temperature.
39