Zenoah RedMax EXtreme EXZ2401S Manual De Instrucciones página 24

EX-PS
(1)
SE1
(3)
(4)
(5)
EX-PS
SE2
EX-PS
SE3
EX-PS
SE4
24
(2)
English
6. Set up (EX-PS only)
■ ATTACHING THE PRUNING MECHANISM (SE1)
1. Remove the cap on the end of the main pipe.
2. Remove the screw screwed into the end of the gear
case.
3. Insert the end of the gear case into the main pipe.
4. Line up the hole on the end of the gear case into
which the screw is to be inserted with the hole on the
main pipe, and screw the screw firmly in.
5. Using a wrench, screw in the bolt provided to fix the
mechanism into place.
(1) Main pipe (2) Gear case
(3) Screw hole (4) Fastening bolt
(5) Bolt
A standard package contains the items as shown
below. (SE2)
(1) Guide bar (2) Saw chain
(3) Gase case (4) Sprocket
(5) Chain tension adjust screw
(7) Chain tensioner nut
Install the guide bar and the saw chain on the gear
case as follows.
WARNING
The saw chain has very sharp edges. Use
protective gloves for safety.
1. Loosen a nut and remove the chain cover.
2. Mount the guide bar then fit the saw chain around
the bar and sprocket. (SE3)
WARNING
Pay attention to the correct direction of the saw
chain
3. Fit the chain tensioner nut into the lower hole of the
guide bar, then install the chain cover, and fasten
the mounting nut to finger tightness. (SE3)(SE4)
(1) Hole (2) Moving direction
(3) Chain tensioner nut
(6) Nut
(8) Chain cover