Emission Levels - Festool SHINEX RAP 150 FE Manual De Instrucciones Original

Ocultar thumbs Ver también para SHINEX RAP 150 FE:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 21
the rotating accessory and cause loss of
control or kickback.
– Do not attach a saw chain woodcarving
blade or toothed saw blade. Such blades
create frequent kickback and loss of control.
Safety Warnings Specific for Polishing
Operations
– Do not allow any loose portion of the
polishing bonnet or its attachment
strings to spin freely. Tuck away or trim
any loose attachment strings. Loose and
spinning attachment strings can entangle
your fingers or snag on the workpiece.
– Prevent liquid polish from entering the
machine. The penetration of liquid polish
into the electric power tool increases the risk
of an electric shock.
5.3

Emission levels

Levels determined in accordance with EN
60745 are typically:
Sound pressure level
Noise level
Measuring uncertainty
allowance
CAUTION
Operating noise
Damage to hearing
Use ear protection!
Vibration emission value a
three directions) and uncertainty K mea-
sured in accordance with EN 60745:
Machine housing
Additional handle
The specified emissions values (vibration,
noise)
– are used to compare machines.
– They are also used for making preliminary
estimates regarding vibration and noise
loads during operation.
– They represent the primary applications of
the power tool.
L
= 81 dB(A)
PA
L
= 92 dB(A)
WA
K = 3 dB
(vector sum for
h
2
a
< 2,5 m/s
h
2
K = 1,5 m/s
2
a
< 2,5 m/s
h
2
K = 1,5 m/s
Increase possible for other applications, with
other insertion tools or if not maintained ad-
equately. Take note of idling and downtimes
of machine!
6
Operation
WARNING
Unauthorised voltage or frequency!
Risk of accident
The mains voltage and the frequency of
the power source must correspond with
the specifications on the machine's name
plate.
In North America, only Festool machines
with the voltage specifications 120 V/60
Hz may be used.
The switch [1-4] is an on/off switch (press =
ON, release = OFF).
The locking button [1-3] can be engaged to
operate in continuous mode. Press the switch
again to release the knob.
7
Settings
WARNING
Risk of injury, electric shock
Always pull the plug out of the socket be-
fore performing any type of work on the
machine!
7.1
Electronics
The machine features full-wave electronics
with the following features:
Smooth start-up
The electronically controlled smooth start-up
ensures that the machine starts up jolt-free.
Speed control
The speed reached when the switch [1-4] is
pressed all the way in can be set to between
600 and 2100 rpm using the adjusting wheel
[1-2]. This enables you to optimise the cut-
ting speed to suit the surface (see table).
The machine is fitted with an accelerator
switch: pressing the on/off switch harder
increases the speed. The speed can be reg-
ulated steplessly between 400 rpm and the
speed preset on the adjusting wheel.
SHINEX
GB
13

Publicidad

Tabla de contenido
loading

Tabla de contenido