Li­iOn Battery Display; Technical Data - Hilti SF 10W­A22 Manual Del Usuario

• Use only Hilti-approved battery chargers to charge these batteries. More information is available from
your Hilti Store or from www.hilti.group
3.3 ATC
The product is equipped with the ATC (Active Torque Control) quick-acting electronic cut-out.
If the accessory tool sticks or stalls, the product will suddenly pivot about its own axis in the opposite direction.
ATC detects this sudden pivoting movement of the product and switches the product off immediately.
For ATC to function correctly, the product must be free to pivot.
After an ATC cut-out, switch the product off and then on again.
3.4 Li­ion battery display
The charge status of the Li-ion battery and malfunctions of the power tool are indicated by the display on
the Li­ion battery. The charge status of the Li­ion battery is displayed after pressing one of the two battery
release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks, the power tool is ready for use.
1 LED blinks, the power tool is not ready for use.
4 LEDs blink, the power tool is not ready for use.
Battery charge status cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
If the battery display LEDs blink, please observe the instructions given in the Troubleshooting section.
3.5 Items supplied
Drill / driver, side handle, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4

Technical data

4.1 Drill/driver
Rated voltage
Weight in accordance with EPTA Procedure 01 including B22⁄8.0 battery
Speed
Torque range (15 settings)
Ø drill bit (softwood)
Ø drill bit (hardwood)
Ø drill bit (metal)
4.2 Battery
Battery operating voltage
Ambient temperature
*2130485*
Meaning
Charge status: 75 % to 100 %
Charge status: 50 % to 75 %
Charge status: 25 % to 50 %
Charge status: 10 % to 25 %
Charge status: < 10 %
The battery has overheated or is completely dis-
charged.
The power tool is overloaded or has overheated.
2130485
21.6 V
3.3 kg
1st gear 0 /min ... 310 /min
2nd gear 0 /min ... 530 /min
3rd gear 0 /min ... 1,210 /min
4th gear 0 /min ... 2,100 /min
2 Nm ... 12 Nm
1.5 mm ... 50 mm
1.5 mm ... 20 mm
1.5 mm ... 13 mm
21.6 V
−10 ℃ ... 60 ℃
English 17