Transport And Storage Of Cordless Tools - Hilti SF 10W­A22 Manual Del Usuario

7.2

Transport and storage of cordless tools

Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault
The power tool doesn't run.
The power tool doesn't work
and all four LEDs blink.
The power tool doesn't work
and one LED blinks.
The on/off button cannot be
pressed, i.e. the button is
locked.
The battery runs down more
quickly than usual.
The battery doesn't engage
with an audible double click.
The power tool or battery
gets very hot.
*2130485*
Possible cause
The battery is not fully inserted.
Low battery.
The power tool has been over-
loaded briefly.
The overheating cut-out has been
activated.
Low battery.
The battery is too hot or too cold.
The forward/reverse selector
switch is in the middle position.
Very low ambient temperature.
The retaining lugs on the battery
are dirty.
The tool is overloaded (application
limits exceeded).
2130485
Action to be taken
▶ Push the battery in until it
engages with an audible double
click.
▶ Change the battery and charge
the empty battery.
▶ Release the control switch and
then press it again.
▶ Allow the power tool to cool
down. Clean the air vents.
▶ Change the battery and charge
the empty battery.
▶ Bring the battery to the recom-
mended operating temperature.
▶ Push the forward/reverse switch
to the left or right.
▶ Allow the battery to warm up
slowly to room temperature.
▶ Clean the retaining lugs and
push the battery in until it
engages. Contact Hilti Service
if the problem persists.
▶ Pay attention to the power
and performance rating of the
product before using it, i.e
check its suitability for the job
on hand. See "Technical data"
section.
English 21