Electrical Connection / Plug Connections - Waeco MagicSafe MS650 Instrucciones De Montaje Y De Uso

MS-650.qxd 13/08/03
Electrical connection / plug connections, P1 (see ✎ D 1)
GREY/WHITE (P1.3)
Route the grey/white wire to the back of the car and connect to a wire
which goes to earth when the boot (trunk is American) is opened. If the
vehicle has a boot (trunk) light, then such a wire can usually be located
behind the lamp.
If no such wire exists, then install an additional pin switch giving off a
ground signal when the trunk is opened.
GREEN/RED (P1.4)
This is the window lift or headlight flasher output. This wire gives a 10 or
25 second earth pulse whenever the alarm system (blue button) is armed
or the grey button is pressed for 3 seconds. The close pulse is cancelled
whenever the transmitter is used to activate or deactivate the alarm
system (blue button).
The additional function can be cancelled by changing program switch
setting to 2-1. The duration of the close pulse is determined by the setting
of software switch 2-2. (see Software adjustments).
Please note that a comfort module or headlight flasher relay may be
required for some corresponding installations. The maximum current at
the outlet may be 0.15A.
Electrical connection / plug connections, P2 (see ✎ D 2)
The magic safe MS-650 alarm system has universal central door locking
connections built into the alarm system for to operate both serial central
locking systems (all types) and central door locking motors. The wiring
colours and their functions are as follows:
P2.1 GREY/RED
P2.2 RED/YELLOW
P2.3 GREY/YELLOW
P2.4 BLUE/YELLOW
12:58 Page 46
Lock together
Lock normally open
Lock normally closed
unlock normally closed
46