Water Connection - Avanti W892F Manual De Instrucciones

The end of faucet spout should be longer than 10mm (0.4"), or the connector cannot be fixed properly.
Water leakage could develop.
?
Con nect the water inlet hoses to the connectors in water inlet valves by turning the connecting
nuts.
?
Connect the other ends of water inlet hoses to the faucets by turning the connecting nuts.
?
If you have both cold and hot water supplied, please make sure to connect the inlet hoses by cold
to cold and hot to hot.
NOTE: Be sure the rubber rings are inside the connecting nuts.
?

WATER CONNECTION

For normal kitchen-sink tap only use the inlet hose with cold water inlet.
Connect the inlet hose to the male hose thread adapter by turning it clockwise to be fixed tightly.
Make sure to insert the rubber ring enclosed. Then connect tightly to your sink.
Note:
Some faucets may require you to also use the female hose thread adapter between the male
adapter and your sink faucet as shown below. Make sure the rubber ring is inserte d and
connect to your sink.
If water leaks from faucet connection or washer connection, turn off water and
tighten fully using a wrench. Be careful not to over tighten and damage water
connection. Turn on water supply and make sure no leaks are present
9
.