Xylem Jabsco 42755 Serie Manual De Instrucciones página 4

Installation/Mounting
CAUTION: Not For Continuous Duty, Intermittent Duty Only
CAUTION: Installation Notes: To avoid the risk of fire. Be sure that
the area where pump is installed is isolated from gas, fuel tanks,
electrical wiring looms or flammable substances. Failure to do so
may cause injury or death.
CAUTION: Installation Notes: To avoid the risk of fire. Do not install
this product if visible damaged. If damage exposes electrical
contacts, electrical sparks could ignite fuel fumes. Failure to do so
may cause injury or death.
1: Select pump location. Pump must be installed in a dry, ventilated
area.
Figure 2.
Horizontal
Horizontal
2: Connect fittings supplied
with the pump to the vessels
plumbing. Use ½" (13mm)
I.D. flexible hose (preferably
braided or reinforced) to
reduce vibration through the
plumbing system (Figure 1).
Use hose clamps on the slip on
barb hose connectors.
Important: Install strainer pump
inlet to protect valves from
debris.
3: Fasten pump to a flat surface. If
mounting vertically; install with
pumphead down (Figure 2)
Do not over tighten screws to
allow rubber mounts to absorb
vibration.
4: Install inlet (A) and discharge
(B) fittings. Firmly push slide
clips (C) forward to lock fittings
in place. – Figure 3
Figure 3.
Inlet Strainer (A)
Figure 4.
Water
Tank
Do Not Plumb Autofill to
Pump Suction Line
4
Vertical
Vertical
City Water
Inlet
Autofill Tank Valve,
NOTE: Do Not Submerge NOTE: Do Not Submerge
Figure 1.
Discharge (B)
Water
Heater
Check
Valve
Pumpgard
Strainer
Plumb to Tank