DeWalt DW723 Manual De Instrucciones página 5

DW723 MOUNTING PROCEDURE CHART
Left Side
DW703
DW705
DW706
DW708
DW712
DW713
DW715
DW716
DW717
DW718
1 = Long screw, Head on bottom
2 = Short screw, Head on bottom
3 = Long screw, Head on top
4. Once the carriage bolt (hardware bag) is installed per Mounting
Procedure Chart, assemble a flat washer; lock washer and nut
onto the bolt. Tighten the bolts finger tight.
Right Side
1 1
1 1
1 1
1 2
1 2
1 1
1 1
1 1
2 1
3 2
5. Repeat procedure on the other end of the bracket.
6. Move the 2 x 4 to the other side of the saw to hold the other end
of the saw up in order to access the saw base.
7. Feed carriage bolts through the other bracket and the base of
the saw as before. Ensure both brackets are parallel to each
other.
8. To place the saw onto the stand, grasp and lift saw by mounting
bracket assembly by the release levers. These levers do not
lock the saw laterally in place but merely serve as a means of
mounting the saw to the beam.
9. Approach the beam with saw/bracket
assembly tilting toward your body slightly.
Engage the concave front lip of the mounting
bracket with rounded edge of beam. One of
the brackets must engage the locator clip
(G) to prohibit lateral movement of the saw
during use.
10. When front edge of the beam and locking locator clip are
engaged, a slight downward pivot will allow secure engagement
of the rear levers to back of beam. Rock the saw gently on the
brackets to verify locking in position.
11. Adjust the saw position as necessary to have the blade
perpendicular to the beam when in the 0 degree miter position.
12. Tighten the four nuts holding the saw to the brackets securely.
3
G